Article number: 822122
The receiver can be programmed with one transmitter at a time. If additional transmitters are programmed, the current transmitter will be replaced. Store the transmitter in the receiver as follows:
1. Start the transmitter as instructed and hold any button pressed.
2. On the receiver (fig. 2): Hold the "Code" button until the relay LEDs light up and then release it. The receiver remains in listening mode for 8-10 seconds.
3. Continue to press the transmitter button until the receiver button finds the transmitter. Relay LEDs will flash three times. Note that it may take up to ten seconds before the receiver will find the transmitter.
(Fig. 3 shows the connection of electrical cables in the receiver)
This transmitter has been discontinued, replaced by a complete Åkerström radio unit.